Skip to content

15N20 steel heat treatment

Band-saw steel and the bright layer in pattern-welded damascus. Tough, fine grained, resists etching dark. Typical practice for 15N20: austenitize at 790 to 815 °C (1455 to 1500 °F), quench (fast oil), then temper at 175 to 230 °C (345 to 445 °F).

Austenitize
790 to 815 °C
1455 to 1500 °F
Temper
175 to 230 °C
345 to 445 °F
Quench
Fast oil
Typical hardness
57 to 60 HRC after a 200 C temper

Heat treats almost identically to 1084, which is exactly why the two make an easy damascus pair. The nickel stays bright in ferric chloride etch.

Typical published practice for guidance. Section size, prior condition, furnace accuracy and soak time all shift the right numbers. Verify against your steel supplier's datasheet before hardening anything that matters.

15N20 chemical composition

15N20 chemical composition in weight per cent
ElementSymbolWeight %
CarbonC0.75
ManganeseMn0.4
NickelNi2

These are the producer's typical values, not a standard range. Nickel band steel. Also known as: 75Ni8, 1.5634, L6 (loose).

15N20 critical temperatures

Estimated critical temperatures for 15N20
TemperatureWhat it meansEstimateEquation
Ac1Lower critical temperatureabout 685 °C (1265 °F)Ac1 = 723 - 10.7 Mn - 16.9 Ni + 29.1 Si + 16.9 Cr + 6.38 W
Ac3Upper critical temperatureabout 704 °C (1299 °F)Ac3 = 910 - 203 sqrt(C) + 44.7 Si - 15.2 Ni + 31.5 Mo + 104 V + 13.1 W
MsMartensite startabout 174 °C (346 °F)Ms = 539 - 423 C - 30.4 Mn - 17.7 Ni - 12.1 Cr - 7.5 Mo

Estimates from the mid-range composition, with element amounts in weight per cent. Correlations like these scatter by about 20 to 25 °C against measurement, and real values shift with heating rate. Source: K.W. Andrews, "Empirical formulae for the calculation of some transformation temperatures", Journal of the Iron and Steel Institute, 203 (1965) 721-727.

Questions

What temperature do you harden 15N20 steel at?
Austenitize 15N20 at 790 to 815 °C (1455 to 1500 °F), then quench: fast oil. This is typical published practice; section size and furnace accuracy shift the right number.
What temperature do you temper 15N20 at?
Temper 15N20 at 175 to 230 °C (345 to 445 °F). Typical hardness: 57 to 60 HRC after a 200 C temper.
What do you quench 15N20 steel in?
Fast oil. Heat treats almost identically to 1084, which is exactly why the two make an easy damascus pair. The nickel stays bright in ferric chloride etch.
What is 15N20 steel equivalent to?
Other designations for 15N20, or for its nearest equivalent where marked "near": 75Ni8, 1.5634, L6 (loose). Check the chemistry on your supplier's datasheet before treating them as the same steel.

Enter your own composition and get the numbers, with sources.

Heat treatment numbers for common steels, each traced to its source paper. About HeatTreat

Get HeatTreat on Google Play