M36 × 3.0 tap drill size and clearance hole
To tap M36 × 3.0, drill 33.0 mm (1.2992 in) for 75% thread. For a screw to pass through, drill a 39.0 mm (1.5354 in) clearance hole. M36 × 3.0 is an ISO metric fine thread with a 36.0 mm major diameter and a 3.0 mm pitch.
- Tap drill, 75% thread
- 33.0 mm
- 1.2992 in
- Clearance hole, normal fit
- 39.0 mm
- 1.5354 in
- Pitch
- 3.0 mm
- fine pitch
- Major diameter
- 36.0 mm
- 1.4173 in
Tap drill sizes for M36 × 3.0
| Thread engagement | Drill | Diameter (in) | Use it for |
|---|---|---|---|
| 75% thread | 33.0 mm | 1.2992 in | The usual choice for most materials |
| 50% thread | 34.5 mm | 1.3583 in | Hard or tough materials: easier tapping, fewer broken taps |
Clearance holes for M36 screws
| Fit | Drill | Diameter (in) | Use it for |
|---|---|---|---|
| Close | 37.0 mm | 1.4567 in | Accurate location, well-aligned holes |
| Normal | 39.0 mm | 1.5354 in | General assembly |
| Loose | 42.0 mm | 1.6535 in | Several fasteners, or holes that may not line up |
M36 × 3.0 thread dimensions
| Dimension | Value |
|---|---|
| Thread series | ISO metric fine thread |
| Major diameter | 36.0 mm |
| Pitch diameter | 34.051 mm |
| Minor diameter | 32.319 mm |
| Pitch | 3.0 mm |
Head sizes for M36 screws and bolts
| Head type | Head diameter | Head height | Across flats | Drive | Standard |
|---|---|---|---|---|---|
| Socket Head Cap Screw | 54.0 mm | 36.0 mm | n/a | hex socket 27.0 | DIN 912, ISO 4762 |
| Hex Head Bolt | n/a | 22.5 mm | 55.0 mm | external hex 55 | DIN 933, ISO 4017 (full thread), DIN 931, ISO 4014 (partial thread) |
Questions
- What size drill bit do I use for an M36 × 3.0 tap?
- Use a 33.0 mm (1.2992 in) drill for 75% thread, the usual choice. In hard or tough material, a 34.5 mm (1.3583 in) drill gives 50% thread and taps more easily.
- What is the clearance hole for an M36 screw?
- Drill 39.0 mm (1.5354 in) for a normal fit. Use 37.0 mm (1.4567 in) for a close fit, or 42.0 mm (1.6535 in) for a loose fit that forgives misaligned holes.
- What is the pitch of M36 × 3.0?
- M36 × 3.0 has a 3.0 mm pitch, measured from one thread crest to the next. It is the fine pitch for M36; the coarse pitch is M36 × 4.0.
- What size spanner and hex key fit an M36 bolt?
- An M36 hex head bolt takes a 55 mm spanner or socket. An M36 socket head cap screw takes a 27.0 mm hex key.
Every thread on this site, in your pocket.
Screw sizes, tap drills and clearance holes for the workshop, offline. About Nuts & Bolts