M30 × 2.0 tap drill size and clearance hole
To tap M30 × 2.0, drill 28.0 mm (1.1024 in) for 75% thread. For a screw to pass through, drill a 33.0 mm (1.2992 in) clearance hole. M30 × 2.0 is an ISO metric fine thread with a 30.0 mm major diameter and a 2.0 mm pitch.
- Tap drill, 75% thread
- 28.0 mm
- 1.1024 in
- Clearance hole, normal fit
- 33.0 mm
- 1.2992 in
- Pitch
- 2.0 mm
- fine pitch
- Major diameter
- 30.0 mm
- 1.1811 in
Tap drill sizes for M30 × 2.0
| Thread engagement | Drill | Diameter (in) | Use it for |
|---|---|---|---|
| 75% thread | 28.0 mm | 1.1024 in | The usual choice for most materials |
| 50% thread | 29.0 mm | 1.1417 in | Hard or tough materials: easier tapping, fewer broken taps |
Clearance holes for M30 screws
| Fit | Drill | Diameter (in) | Use it for |
|---|---|---|---|
| Close | 31.0 mm | 1.2205 in | Accurate location, well-aligned holes |
| Normal | 33.0 mm | 1.2992 in | General assembly |
| Loose | 35.0 mm | 1.3780 in | Several fasteners, or holes that may not line up |
M30 × 2.0 thread dimensions
| Dimension | Value |
|---|---|
| Thread series | ISO metric fine thread |
| Major diameter | 30.0 mm |
| Pitch diameter | 28.701 mm |
| Minor diameter | 27.546 mm |
| Pitch | 2.0 mm |
Head sizes for M30 screws and bolts
| Head type | Head diameter | Head height | Across flats | Drive | Standard |
|---|---|---|---|---|---|
| Socket Head Cap Screw | 45.0 mm | 30.0 mm | n/a | hex socket 22.0 | DIN 912, ISO 4762 |
| Hex Head Bolt | n/a | 18.7 mm | 46.0 mm | external hex 46 | DIN 933, ISO 4017 (full thread), DIN 931, ISO 4014 (partial thread) |
Questions
- What size drill bit do I use for an M30 × 2.0 tap?
- Use a 28.0 mm (1.1024 in) drill for 75% thread, the usual choice. In hard or tough material, a 29.0 mm (1.1417 in) drill gives 50% thread and taps more easily.
- What is the clearance hole for an M30 screw?
- Drill 33.0 mm (1.2992 in) for a normal fit. Use 31.0 mm (1.2205 in) for a close fit, or 35.0 mm (1.3780 in) for a loose fit that forgives misaligned holes.
- What is the pitch of M30 × 2.0?
- M30 × 2.0 has a 2.0 mm pitch, measured from one thread crest to the next. It is the fine pitch for M30; the coarse pitch is M30 × 3.5.
- What size spanner and hex key fit an M30 bolt?
- An M30 hex head bolt takes a 46 mm spanner or socket. An M30 socket head cap screw takes a 22.0 mm hex key.
Every thread on this site, in your pocket.
Screw sizes, tap drills and clearance holes for the workshop, offline. About Nuts & Bolts